Heat Presses

For hassle-free processing of our transfer papers, precise pressure distribution and a consistent temperature are essential. The following presses easily meet these requirements and are highly recommended:

* TheMagicTouch HTP123 Basic
* TheMagicTouch HTP123 Pro
* TheMagicTouch HTP256 Plus

If the press is difficult to close, it doesn’t always guarantee that the pressure applied to the product is sufficient. The mechanical condition and contraction of the press play a crucial role. For an accurate diagnosis, please fill out our support form and upload a few photos or a video of the process. We are ready to help you with a precise solution.

We consider 6 bar / 87 psi to be high pressure. On manual presses, pressure is not digitally displayed, which can make adjustment difficult. For detailed instructions on how to set and adjust the pressure on your manual press, please refer to our support page: LINK

No, you do not, and it is often discouraged. Teflon acts as a heat deflector, which can negatively affect the transfer process during shorter press times.

* Use Teflon ONLY for sublimation: It protects the rubber mat and the heat platen from ink contamination.
* For all other transfer applications (like Flex and Transfer Paper), use TheMagicTouch Release Paper.

Many applications are small (e.g., logos on pockets, sleeves, or children’s garments). A smaller lower platen allows you to isolate the pressing area. This is essential to prevent irregularities like buttons or zippers from entering the heat press area, which disrupts pressure distribution. A small platen ensures you only press the design.

While all heat presses operate on a standard 230/110 volt outlet, there are three critical safety and performance points:

1. Reserve an electrical circuit: Due to the relatively high current draw, reserving a dedicated circuit is advisable to prevent tripping the circuit breaker.
2. Use grounded outlets: This is crucial for safety in the event of an internal short circuit in the press.
3. Avoid extension cords: If unavoidable, ensure you use a cord and outlet with the proper certification that can handle the press’s maximum load (Watts). The cord’s maximum rating must always be lower than the combined wattage of the equipment plugged into it.

A heat press requires minimal maintenance, but the little it needs is important for smooth operation. Specifically, keep the moving parts clean and apply high-temperature grease in time. Do not use regular grease, as the press’s heat can harden it, rendering it useless.

We are happy to help you with this assessment. Fill out our support form and specify the press you are using. We will then advise you as quickly as possible regarding the press’s suitability and potential limitations.